यो Article आफ्नो भाषा मा अवस्थित छैन, हेर्नुहोस्: English (en),
अथवा गुगल अनुवाद प्रयोग:  

Rapid Multiplication of Banana Plants in the Field

Published: 1999-12-19
From: ECHO Development Notes (EDN) | EDN Issue #66

If you have a superior variety of banana, and want to make it widely available, is there a shortcut or do you need to wait for pups to form naturally? Dr. Rowe shared a method that captured the attention of many at the conference.

“This is the most practical way known to increase the numbers of plants. In fields specifically for production of more planting material, the initial individual plants should be planted at a spacing of 2 x 2 meters (6.3 x 6.3 ft) as compared to a spacing of about 3.5 2 x 3.5 meters (8.9 x 11.4 ft) in fields for fruit production.”

The sequential procedures are illustrated with photos as follows.

 

Step 1 shows the approximate size the initial plants should be for beginning the rapid multiplication process.
Step 1 shows the approximate size the initial plants should be for beginning the rapid multiplication process.
Step 2. Remove three of the outer sheaves from the trunk all the way to the base of the plant.
Step 2. Remove three of the outer sheaves from the trunk all the way to the base of the plant.

 

 

 

 

 

 

 

 

 

 

 

Step 3. Remove all leaves, double the trunk to a shape of the number "7," and drive a thin flat stake which is 5 cm (2.5 in) wide all the way through the center of the trunk at the height shown.
Step 3. Remove all leaves, double the trunk to a shape of the number “7,” and drive a thin flat stake which is 5 cm (2.5 in) wide all the way through the center of the trunk at the height shown.
Step 4. Sprinkle a handful of fertilizer (urea or a complete fertilizer) around the base of the trunk.
Step 4. Sprinkle a handful of fertilizer (urea or a complete fertilizer) around the base of the trunk.

 

 

 

 

 

 

 

 

 

 

 

Step 5. Cover the fertilizer and base of the trunk with about 7 cm (3 in) of soil.
Step 5. Cover the fertilizer and base of the trunk with about 7 cm (3 in) of soil.
Step 6. The completed process for inducing multiple sucker development.
Step 6. The completed process for inducing multiple sucker development.

 

 

 

 

 

 

 

 

 

 

 

 

Step 7. The abundance of suckers produced about 4 months later
Step 7. The abundance of suckers produced about 4 months later

All the suckers (Step 7) should be dug and the corms prepared by cutting the trunks off at about (5.1 x 7.6 cm) (2-3 in) above the corms. Roots should be removed by cutting them off at the surface of the corms. Corms 10.1 cm (4 in) and larger in diameter can be planted directly in the field. Smaller corms can be allowed to grow 3-4 months in plastic bags (with a soil capacity of about 2 liters) before being planted in the field.

For additional multiplications, replant the largest corm in the spot from which the corms were dug. Then, after the plant from this corm is about the size shown in Step 1, the multiplication process can be repeated.

The method works because the apical dominance of the growing point has been destroyed by the stake driven through the middle of the stem.

Cite as:

ECHO Staff 1999. Rapid Multiplication of Banana Plants in the Field. ECHO Development Notes no. 66